Radon Levels in Stevensville, VA
Stevensville is in King And Queen County. Radon data is tracked at the county level by the EPA and CDC.
EPA predicts average indoor levels below 2 pCi/L in this county · Source: EPA, CDC
Tipper's take on radon in Stevensville
Stevensville is in King And Queen County, EPA Zone 3, the lowest risk classification. The EPA predicts average indoor radon levels below 2 pCi/L here. CDC data puts the county average at 6.5 pCi/L, though the sample size is small. Treat it as directional.
Lower risk isn't no risk, though. Radon depends on your specific home's foundation, soil, and construction as much as county-level geology. Homes with basements or older foundations can test above 4 pCi/L even in Zone 3 areas.
Tipper's take: if you've never tested, a one-time check is cheap and quick. If you've already tested below 2 pCi/L, retest every two years or after any major renovation.
Sources: EPA Radon Zone Map, CDC Environmental Public Health Tracking
Test Your Home in Stevensville
A short-term test kit costs about $15, includes the lab fee, and gives you a result in 48 hours. It's the only way to know your home's actual radon level.
Radon Professionals Serving Virginia
No contractors in our directory are listed specifically for Stevensville. These certified pros serve Virginia and may cover your area.
Full County Data
Radon data is tracked at the county level. For state comparisons, nearby counties, and detailed analysis, see the full county page.
King And Queen County, VA: Full Radon Data →Radon FAQ: Stevensville, VA
What is the radon risk in Stevensville?
Stevensville is in King And Queen County, which the EPA classifies as Zone 3 (Low risk). The county average is 6.5 pCi/L. The EPA recommends testing every home regardless of zone. Radon levels vary house to house.
How do I test my home in Stevensville for radon?
Place a short-term radon test kit in the lowest livable level of your home for 48 hours under closed-house conditions. Kits cost about $15 and include the lab fee. Keep windows and exterior doors closed during the test (normal entry/exit is fine). Results come back in about a week.
What should I do if radon is high in my Stevensville home?
If your test result is at or above 4 pCi/L, the EPA recommends installing a mitigation system. A certified contractor can install one for $800–$2,000 in most cases. The system runs continuously and typically brings levels well below 2 pCi/L. Retest after installation to confirm.