Radon Levels in Crownsville, MD
Crownsville is in Anne Arundel County. Radon data is tracked at the county level by the EPA and CDC.
EPA predicts average indoor levels between 2–4 pCi/L in this county · Source: EPA, CDC
Tipper's take on radon in Crownsville
Crownsville is in Anne Arundel County, EPA Zone 2, a moderate risk classification. The EPA predicts average indoor radon levels between 2 and 4 pCi/L here. CDC data from Anne Arundel County puts the average measured radon level at 2.9 pCi/L.
"Moderate" is the zone people underestimate most. Some homes in Crownsville will test at 1 pCi/L, others at 7 pCi/L. The county average doesn't tell you which side your home falls on.
A $15 test kit answers the question for good. If you're below 4 pCi/L, you can stop thinking about it. If you're above, mitigation systems in Maryland typically cost $800–$2,000 and work well.
Sources: EPA Radon Zone Map, CDC Environmental Public Health Tracking
Test Your Home in Crownsville
A short-term test kit costs about $15, includes the lab fee, and gives you a result in 48 hours. It's the only way to know your home's actual radon level.
Radon Professionals Serving Maryland
No contractors in our directory are listed specifically for Crownsville. These certified pros serve Maryland and may cover your area.
Full County Data
Radon data is tracked at the county level. For state comparisons, nearby counties, and detailed analysis, see the full county page.
Anne Arundel County, MD: Full Radon Data →Radon FAQ: Crownsville, MD
What is the radon risk in Crownsville?
Crownsville is in Anne Arundel County, which the EPA classifies as Zone 2 (Moderate risk). The county average is 2.9 pCi/L. The EPA recommends testing every home regardless of zone. Radon levels vary house to house.
How do I test my home in Crownsville for radon?
Place a short-term radon test kit in the lowest livable level of your home for 48 hours under closed-house conditions. Kits cost about $15 and include the lab fee. Keep windows and exterior doors closed during the test (normal entry/exit is fine). Results come back in about a week.
What should I do if radon is high in my Crownsville home?
If your test result is at or above 4 pCi/L, the EPA recommends installing a mitigation system. A certified contractor can install one for $800–$2,000 in most cases. The system runs continuously and typically brings levels well below 2 pCi/L. Retest after installation to confirm.